Search online, other users have encountered this problem using the same make and model controller.

You may need to restart the Pi and try to configure the controller once more. If the controller is working on other machines, it may be a compatibility issue with the Pi. Development/Driver Station PC Address: Automatically assigned by Raspberry PI DHCP Server to Development/Driver Station PC when Ethernet is Connected. Make sure the controller is working on other devices. Raspberry PI IP Address: 10.XX.YY.2 (where XX is first two digits of team number, YY is last two digits of team number). The cable needs be completely inserted into the port, but shouldn't require excessive force. If RetroPie isn't recognizing the controller, verify there are no obvious hardware issues causing the disconnect. The custom controller profiles are saved in the following file path: /opt/retropie/configs/ RetroPie doesn't recognize the controller If the file isn't saving, you will need to make sure both the SD card and destination folders are writable. Verify you have taken the proper steps to save the custom controller configuration. If the controller is only slow when using the Pi, you may need to restart the device and configure it once again. Try testing the controller on another device or computer to isolate the problem. However, it can happen with wired ones as well. This issue is common with wireless controllers. These are some of the most common issues facing RetroPie users with controllers. These are available online at many stores for under $10.As always, if something isn't working right we've got you covered. You will need to purchase a standard Wall-wart (between 6-16 VDC output, up to 3 Amps, with a center-positive connector with an inner diameter of 2.1mm and an outer diameter of 5.5mm. VMX-pi comes with a battery cable for connecting to the Power Distribution Panel VMX-pi also comes with a “Wall-Wart” cable for powering VMX-pi and your Raspberry Pi when not on a FRC robot. Instructions are also available at VMX-rtk online to build your own SD card image, however Kauai Labs recommends the VMX Robotics Toolkit SD card – which was created to save you the time and trouble of creating your own SD card. PiZero Colored Weather Station : I want to show you in this project how to build a nice looking weather station based on Raspberry Pi Zero W for wall mount with weather forecast and coloured 2.8 inch TFT screen.

This is a high-quality SD Card for your Raspberry Pi with many pre-installed software tools for FRC robotics, and also has approximately 16GB of extra space for storing videos taken on your robot during practice or competition.

Kauai Labs has created the VMX Robotics Toolkit, available for purchase at the Kauai Labs Store. The first step is to assemble your Raspberry Pi 3 and VMX-pi, as shown at VMX-pi online.

Frc driver station raspberry pi